- #Router configuration packet tracer manual#
- #Router configuration packet tracer download#
- #Router configuration packet tracer mac#
These differences are the format of the used IP address and the used keywords. The format of IPv6 Ping is a little difference than IPv4 Ping. As IPv4, with IPv6, we also use ping, but this time it is called IPv6 Ping. To check the connectivity between two node, we use ping. Let’s check the IPv6 address that we have manually assigned with “ show ipv6 interface brief” command. Here, both of these directly connected interfaces are in the same subnet, the Network ID is same (2001:AAAA:BBBB:CCCC::/64). Let’s configure Gigabit Ethernet 0/0 interface of Router 2 manually. If we do not use EUI-64 format address, we have to write the whole IPv6 Address to the configuration line. Let’s check the IPv6 address that is created with EUI-64 format with “ show ipv6 interface brief” command.
#Router configuration packet tracer mac#
The real EUI-64 Global Unicast Address will be created with this address and MAC address after IPv6 configuration. Here, our IPv6 address and prefix-length are 2001:AAAA:BBBB:CCCC::/64. To configure an interface with EUI-64 format (Extended Unique Identifier), firstly we will go under the interface, then we will use “ ip address ipv6-address/prefix-length eui-64” command. After that, this created interface id is appended to the network id. With this format, basically, interface id of the whole IPv6 adderess is ceated with the help of the MAC address. It is a specific format that we have also talked about before. Router 2 (config)# interface FastEthernet0/1Ĭonfigure EUI-64 Format Global Unicast AddressĮUI-64 format is the IPv6 format used to create IPv6 Global Unicast Addresses. Router 2 (config)# interface FastEthernet0/0 Router 1 (config)# interface FastEthernet0/1 Router 1 (config)# interface FastEthernet0/0 Let’s enable IPv6 on two interfaces of each router. To enable IPv6 under an interface, we will use “ ipv6 enable” command. This can be used before both interface configurations and IPv6 Routing Protocol configurations.Īfter enabling IPv6 globally, we should enable IPv6 under the Interfaces. With this Cisco command, IPv6 is enabled globally on the router. So, let’s go to the IPv6 Configuration steps and configure IPv6 for Cisco routers.Īfter going to the configuration mode with “ configure terminal” command, to enable IPv6 on a Cisco router, “ ipv6 unicast-routing” command is used.
#Router configuration packet tracer manual#
Configure Manual Global Unicast Address.
![router configuration packet tracer router configuration packet tracer](https://img.sysnettechsolutions.com/How-to-Configure-RIP-Routing-in-Cisco-Packet-Tracer-RIP-Konfigurasyonu-03.png)
In this configuration lesson, we will follow the below IPv6 Configuration steps:
#Router configuration packet tracer download#
You can download Packet Tracer IPv6 Lab, in Packet Tracer Labs page.
![router configuration packet tracer router configuration packet tracer](https://itexamanswers.net/wp-content/uploads/2017/07/7.2.1.6-Packet-Tracer-Configuring-Numbered-Standard-IPv4-ACLs-Instructions.jpg)
We will use the below Packet Tracer topology for our IPv6 Config. In this lesson, we will focus on these IPv6 Configuration Steps, IPv6 Configuration on Cisco devices. With this new IP version, IPv6, beside different features, some configuration differencies are also coming. IPv6 is the new version of the most important Network Layer Protocol IP.